Feeder Ports-box of 12

Current Stock:


These ports are the ones used in the Many Ports Feeders and the LessMess Feeders.

They are sold in boxes of 12.


How to Install Ports

1) Make a mark 2.5 inches from the bottom of the bucket.  Drill a small pilot hole at the mark to locate the center of the port.  Use a step drill (size 7/8"-1 3/8")

to drill out for the port. Drill the hole just shy of 1.25" to get a snug fit.  This will make port installation a lot easier.

2) Insert the port into the hole with the BAFFLE HOOD AT THE TOP and the MOUNTING HOLE AT THE BOTTOM.

3)  Driil a 3/16" hole through the mounting hole.

4) Use a 3/16" pop rivet and a backup washer to mount the port.



Place a 2qt funnel upside down in the center of the bucket.  Plug the stem hole with tape or something else.

This will direct the feed toward the ports.

NOTE: A copy of the above directions with supporting pictures are now sent with orders for ports.